How to Create a Stunning Easter Egg Wreath : A Simple DIY

Step-by-Step Instructions

Step 1: Prepare Your Workspace

First things first – clear off a table or counter where you can work comfortably. I like to lay down some newspaper or an old tablecloth to catch any hot glue drips. Plug in your hot glue gun and let it heat up while you organize your supplies.

I sort my plastic eggs by color to make it easier to create a balanced design. This isn’t strictly necessary, but I find it helps me visualize the finished product better. If your eggs come in two halves, snap them together before you begin.

Step 2: Start Gluing Eggs to the Wreath Form

Once your glue gun is hot, it’s time to start attaching eggs to the foam wreath. I begin by placing four eggs at the north, south, east, and west positions of the wreath to create a balanced foundation. Apply a generous amount of hot glue to the bottom of each egg, then press it firmly against the foam wreath form. Hold each egg in place for about 30 seconds to make sure the glue sets.

A word of caution from someone who learned the hard way: hot glue is called “hot” for a reason! Be careful not to burn your fingers. I keep a bowl of cold water nearby just in case.

Step 3: Fill in the Wreath

After placing your first four eggs, continue adding more around the wreath. I like to vary the colors as I go, making sure not to place too many of the same color next to each other. Work your way around the wreath, filling in all the spaces until the foam form is completely covered.

Don’t worry if there are small gaps between some of the eggs – this is normal and won’t be noticeable in the finished wreath. The key is to make sure every egg is securely attached to the foam form with plenty of glue.

I find it’s easiest to work on one section at a time, rather than jumping around the wreath. This helps ensure even coverage and a balanced appearance. Take your time with this step – it’s the most important part of creating your wreath!

Step 4: Add a Second Layer (Optional)

If you want a fuller wreath, consider adding a second layer of eggs on top of the first. This creates more dimension and visual interest. For this layer, I place eggs in the spaces where four eggs meet, creating a slightly raised pattern.

You don’t need to cover the entire wreath with a second layer – even just a few eggs here and there can add nice depth to your creation. I find that adding about 8-10 eggs as a second layer works well for a 12-inch wreath form.

Step 5: Attach a Hanging Ribbon

Once all your eggs are securely attached, it’s time to add a ribbon for hanging. Cut a length of ribbon – I use about one yard, but adjust based on where you’ll be hanging your wreath. Form the ribbon into a loop and secure both ends to the back of the wreath with hot glue.

I like to reinforce this attachment point with a lot of glue, as it will bear the weight of the entire wreath. For extra security, you can pin the ribbon to the foam form with straight pins before adding the glue.

Step 6: Add Decorative Elements (Optional)

At this point, your wreath is technically complete, but you can add extra touches if you’d like! I added a simple bow at the top of my wreath using wired ribbon in a complementary color. You could also attach small spring decorations like artificial flowers, butterflies, or even a small bird’s nest.

If you decide to add a bow, you can either make one yourself or use a pre-made bow from the craft store. Attach it securely with hot glue and, if needed, floral wire for extra support.